Помощь
Оффлайн
Инфо (5)
Epson 7710
после застревания шланга донорки лента чуть изгиб дала и вылезла ошибка 000031, после откл/вкл каретка уходит в лево крючок не опускается и каретка останавливается не доходя до конца в лево и выходит ошибка 000031
помогите?
Страница 1 из 1
Epson 7710 ошибка 000031
| Сообщение #2 Отправлено 26 июня 2024 - 15:39
CR load position excess load error (error code: 000031)
Is there no paper jam paper and foreign object in the CR scanning section?
Go to step 2 Remove the jammed paper and foreign object.
2
Check the CR Lock Lever operation
Does the CR Lock Lever operate correctly when the power is on?
(Is the lowering operation performed correctly?)
Go to step 3 Replace the Inksystem Assy.
3
Check the status of the CR Guide Frame
Is the CR Guide Frame dirty from paper dust or mist? Is a lubrication
shortage occurring?
Go to step 4 Lubricate the CR Unit and CR Gudie Frame
contacting point after cleaning.
4
Check the status of the CR Scale.
Is the CR Scale dirty or damaged?
Go to step 5
Clean, if dirty.
Replace the CR Scale in the case of damage.
Is there no paper jam paper and foreign object in the CR scanning section?
Go to step 2 Remove the jammed paper and foreign object.
2
Check the CR Lock Lever operation
Does the CR Lock Lever operate correctly when the power is on?
(Is the lowering operation performed correctly?)
Go to step 3 Replace the Inksystem Assy.
3
Check the status of the CR Guide Frame
Is the CR Guide Frame dirty from paper dust or mist? Is a lubrication
shortage occurring?
Go to step 4 Lubricate the CR Unit and CR Gudie Frame
contacting point after cleaning.
4
Check the status of the CR Scale.
Is the CR Scale dirty or damaged?
Go to step 5
Clean, if dirty.
Replace the CR Scale in the case of damage.
Поделиться темой:
Страница 1 из 1